Publicidad
Idiomas disponibles
Idiomas disponibles
11. Connect the product to a power source. Refer to
connect the product to a power source on page 12 .
12. Make sure that the height of the brushes below the
drum housing is correct for the operation depth. If it
is necessary, loosen the nuts, adjust the height and
tighten the nuts.
To install the scarifying drum
1. Remove the support plate.
2. Remove the screws and washers from the side
cover.
3. Install the screws with washers in the adjacent holes.
10
To
4. Turn the screws to push the side cover off.
Note:
When the side cover is removed, the axle
hangs loose.
5. Install the scarifying drum on the axle.
6. Install the side cover.
1838 - 003 - 09.02.2023
Publicidad
