Publicidad
Idiomas disponibles
Idiomas disponibles
O = The instructions are not given in this operator's
manual. Let an approved service agent do the
maintenance.
General product maintenance
Clean the product.
Do a check of all safety devices.
Make sure that nuts and screws are
tight.
Examine the tool drum, the drum
axle, the tools and the housing for
wear.
Make sure that the power plug and
extension cable are in good condition
and not damaged.
Do a check of the RCD.
Do a check of the electrical compo-
nents, the cables and the connec-
tions for wear and damages.
Do a check of the drive belt tension.
Make sure that the dust hose is not
damaged and free of blockage.
Empty the dust extractor.
Lubricate the bearing.
Examine the brushes below the drum
housing for wear.
Do a complete servicing and cleaning
of the product.
To tilt the product rearward
WARNING:
below the product, put a blockage to prevent
the product from the unwanted movement.
For some maintenance it is necessary to tilt the product
rearward to get access to the tool drum.
1838 - 003 - 09.02.2023
Daily
X
X
*
*
*
*
*
X
*
*
Before you do a work
12h after service
Each 3 months
*
1. Release the steering lock at the control panel.
Yearly
X
X
*
O
15
Publicidad
