Publicidad
Idiomas disponibles
Idiomas disponibles
EtAl (temperature CALIBRTION):
It allows calibrating the temperature probe (+/- 5°C).
The temperature of a room is not uniform, therefore it is possible that the temperature measured by the radiator is different from
that of another position in the room. The calibration function allows compensating this difference.
Before using this function, the radiator must operate for at least 6 hours
to stabilise the ambient temperature. If you notice that the radiator
does not start heating to the set temperature or starts heating early, it is
recommended to change this parameter.
Lng:
It allows selecting one of the two languages:
-
FrA French (default)
-
Eng English
Press knob B to confirm the selection.
If the language has been set to English, the text that will be displayed will be different from the
text indicated above, as shown in the table opposite.
Note: If the parameter setting sequence is not completed, the electronics will automatically return
to the Stop status after a few seconds and the selections made by pressing knob B will remain
stored.
4.5 PROGRAMMING
To access the programming function, turn knob A to Chrono and keep knob B pressed for 5
seconds.
It is now possible to select the desired temperature level between comfort and night/
reduction, in sequence for each day of the week, from 1 to 7, and for each hour.
night
The Comfort temperature value is the one selected with knob A set to Comfort. The Night temperature value is the one selected
with knob A set to Night.
Turn knob B to automatically assign to each hour and then, in sequence, to each day, the Comfort value or the Night value,
depending on which one was selected.
To select Comfort or Night/reduction, just press knob B and the system will switch between Comfort and Night/reduction.
Note: the previously set programming can be adjusted backwards by simply turning knob B in reverse and selecting the desired
French
English
Stop
Stb
HEJ
tEd
Fon
Fun
EtAl
OFS
Lng
Lng
25-EN
Publicidad
