5.
CLEANING OF THE RADIATOR
For your safety, before any cleaning operation, disconnect power supply.
Cleaning operations must be carried out with radiator off and cold.
Do not use abrasive or corrosive products to clean the heating body. Use, for instance, soapy water and then dry the body using a
soft cloth. For plastic parts, controls and humidifier cleaning, use only a dry cloth and avoid contact with chemicals and alcohol.
6.
FAILURES
In case of failure do not use the appliance, disconnect it from power supply and for the repair address only to a technician approved
and authorised to operate on this product.
If the power cable is damaged, it must be replaced only by the manufacturer's after-sale service or qualified personnel.
This appliance is filled with a precise quantity of mineral oil. Reparations that require to open the fluid tank must be carried out by
the manufacturer, its agents or the customer service.
The manufacturer shall not be held responsible for damage to people, animals, or property due to tampering with or improper
intervention to the radiator.
TABLE OF TECHNICAL FAULTS
PROBLEM
The radiator does not
heat
The radiator does not
ensure to reach the
desired temperature in
the room
STATE OF THE RADIATOR
The display does not
show any notice
Radiator in Chrono
mode
Radiator in Comfort or
Chrono mode
Radiator in Comfort or
Chrono mode
Properly working
PROBABLE CAUSE
No power supply.
The program provides
for operation in Night
mode
Malfunction of resistor
or adjustment board
The room temperature
is higher than the
temperature set on the
radiator
The radiator position
affects excessively the
temperature detected in
the room
The radiator power is
insufficient to meet the
need of the room
SOLUTION
Check that the radiator
is electrically powered
Check the programming
setting
Contact a Service Centre
or the dealer
Check the set
temperature
Calibrate the
temperature read by the
radiator, see paragraph
4.4 EtAl/ CALIBRATION
Replace the radiator
with a more powerful
one or add another
radiator
27-EN