Publicidad
Idiomas disponibles
Idiomas disponibles
The radiator is faulty
The radiator is
lukewarm and operates
intermittently
The radiator heats
continuously
Window opening
detection does not work
properly
Expansion noises in
switching on and/or off
phase
The radiator leaks oil
The wall behind the
radiator gets dirty
The radiator does
not follow the set
programming
28-EN
ALL is displayed
The display shows
the symbol
intermittently
Any
Function enabled
Any
Any
Any
Chrono
The temperature sensor
is faulty
The radiator detects an
ambient temperature
close to the set
temperature.
The radiator is installed
near an air stream
(entrance doors,
ventilation holes in the
wall)
The set temperature is
too high
Lowering of
temperature in the
rooms has not exceeded
5°C in the time provided
or
The position of the
radiator does not allow
the probe to detect the
temperature correctly.
The supporting brackets
are not centred and
scrape the radiator.
Defect of the heating
body or lack of sealing
in connectors.
These signs are due to
the quality of the air
in the room and the
formation of dust in the
radiator or the fact that
people regularly smoke
in the room
The day and time are
not set correctly due to
a previous power failure
Contact a Service Centre
or the dealer
If the ambient
temperature is different
from the set temperature,
calibrate the temperature
according to paragraph 4.4
Remove the cause of
the current or move the
radiator.
Correct the set
temperature
-----
Relocate the radiator.
Position brackets
properly.
Contact a Service Centre
or the dealer
Ventilate and keep the
room and the radiator
clean.
Do not smoke in the
room.
This situation does
not legitimate the
replacement of the
radiator under warranty.
Adjust the date and
time as indicated in
paragraph 4.4 HEJ
Publicidad
