VALBERG 10S44 D SAD929C Manual De Instrucciones página 22

C
Useful information
Spray arm
• It is necessary to clean the spray arm regularly for hard
water chemicals will clog the spray arm jets and bearings.
• To clean the spray arm, follow the instructions below:
1. To remove the upper spray arm, hold the nut in the center
still and rotate the spray arm counterclockwise to remove it.
2. To remove the lower spray arm, pull out the spray arm
upward.
40 EN
C
Useful information
3. Wash the arms in soapy and warm water and use a soft
brush to clean the jets. Replace them after rinsing them
thoroughly.
Caring for the dishwasher
Frost precaution
• Please take frost protection measures on the dishwasher
in winter. Every after washing cycles, please operate as
follows:
1. Cut off the electrical power to the dishwasher at the
supply source.
2. Turn off the water supply and disconnect the water inlet
pipe from the water valve.
3. Drain the water from the inlet pipe and water valve. (Use a
pan to gather the water)
41 EN