Descargar Imprimir esta página

Haier HFW7918EIMP Guia Del Usuario página 33

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

GB
It is essential that the manufacturer's recommended installation, maintenance and filter
replacement requirements be carried out for the product to perform as advertised. See
Installation Manual for Warranty information.
Notice
While the testing was performed under standard laboratory conditions, actual perfor-
mance may vary. Replacement Cartridge: HRXWF For estimated costs of replacement
elements please visit our website at www.haierspares.eu.
WARNING!
To reduce the risk associated with ingestion of contaminants:
Do not use with water that is microbiologically unsafe or of unknown quality with-
out adequate disinfection before and after the system. Systems certified for cyst
reduction may be used on disinfected water that may contain filterable cysts.
Notice
To reduce the risk of water leakage or flooding, and to ensure optimal filter perfor-
mance:
Read and follow use instructions before installation and use of this system.
Installation and use MUST comply with all state and local plumbing codes.
Do not install if water pressure exceeds 120 psi (827 kPa). If your water pressure ex-
ceeds 80 psi (552 kPa), you must install a pressure-limiting valve. Contact a plumbing
professional if you are uncertain how to check your water pressure.
Do not install where water hammer conditions may occur. If water hammer condi-
tions exist you must install a water hammer arrester. Contact a plumbing profes-
sional if you are uncertain how to check for this condition.
Do not install on hot water supply lines. The maximum operating water temperature
of this filter system is 1 00º F (38º C).
Protect filter from freezing. Drain filter when temperatures drop below 33ºF (0.6ºC).
Change the disposable filter cartridge every six months or sooner if you observe a
noticeable reduction in water flow rate.
Failure to replace the disposable filter cartridge at recommended intervals may lead
to reduced filter performance and cracks in the filter housing, causing water leakage
or flooding.
This System has been tested according to NSF/ANSI 42, 53, 401 and P473 for the
reduction of the substances listed below. The concentration of the indicated sub-
stances in water entering the system was reduced to a concentration less than or
equal to the permissible limit for water leaving the system, as specified in NSF/ANSI
42, 53, 401 and P473.
Use
29

Publicidad

loading

Este manual también es adecuado para:

Hfw7918eimb