cam CALIBRO Manual De Instrucciones página 20

CALIBRO 6 dicembre 2017 15 lingue_Layout 1 06/12/17 17:38 Pagina 20
INSTRUCTIONS FOR USE
on the seat of the car. The anchorage
points are usually located at the
intersection between the backrest and
the seat.
17. Also find the anchorage point for the
top tether. According to the model of car,
the third anchorage point could be
located in different positions, in the boot
or on the floor of the vehicle.
To find the location of the anchorage
point, consult the vehicle instruction
manual or contact the car manufacturer.
18. Pull the release handle and at the
same time pull the grey strap to pull
out the Isofix connectors.
19. Take hold of the child car seat with
both hands and
connectors inside the guides until they
fasten to the Isofix anchorage points.
A click must be heard on both sides.
Both fastening indicators must turn
green.
20. Press the release handle and at the
same time push the child car seat hard
towards the seat so that it adheres to
the back of the seat. CAUTION: Check,
by pulling the child car seat with your
hands that it is firmly secured to the
car. Check that
indicators are green. CAUTION: the
child car seat must rest entirely against
the backrest of the seat of the car.
21. Lengthen the strap of the top
tether using the tensioning device. It
must be long enough to reach the top
tether anchorage point.
22. Fasten the snap hook of the top
tether to the car.
23. Pull the free end of the top tether
strap to tighten it. Caution: tighten the
strap until the indicator located on the
tensioning device turns green.
Installation for group 2 (15-25 kg.)
using the car seat belts and the
Isofix connectors
24. Before installation, remove the
five-point harness from the car seat.
Note: the insert for small children, the
harness, the buckle, the pads to
protect the buckle, the shoulders and
19
the harness anchoring pin must be
removed and put in a safe place for
possible re-use.
CAUTION: The points where the seat
belts pass are marked in red. Do not
pass the car seat belts in any positions
other than those shown. Follow the
indications given in this manual very
carefully. Fasten the Isofix connectors
as
Installation for group 1 (9-18 kg.).
Place the child in the car seat. Pull out
the seat belt from its retractor.
25. Position the car seat belt on the
child's chest and lap.
26. Fasten the seat belt.
slide the two Make sure that the lap part of the car
seat belt is placed in the lowest
position possible on the child's lap.
Make sure that the car seat belt is held
firmly in the guides located at the sides
of the child car seat.
27. Insert the belt in the red guide
located under the headrest. The seat
belt must be held entirely in the guide.
28. The diagonal part of the car seat
belt must be positioned half way
between the child's neck and shoulder.
both fastening Tighten the car seat belt well, check
that it is not twisted and that it is firmly
in place in the guides on the seat and
under the headrest.
Installation for group 3 (22-36 kg.).
29. Adjust the height of the headrest.
Fit the car seat as described in the
paragraph: Installation for group 2
(15-25 kg.).
30. Check that the lap part of the car
seat belt is positioned in the lowest
possible position on the child's lap.
How to remove the car seat harness
and cover
31. Press the adjuster and at the same
time pull both the safety straps of the
child car seat as firmly as possible.
32. Open the flap at the back of the car
seat.
33. Release both the safety straps from
the metal "T" shaped hook located
explained in the paragraph: