Denver CRP-617 Instrucciones De Uso página 3

POWER CONNECTION
Plug the AC power cord to a household outlet AC source. This unit
is equipped with a battery back up system, it requires a 3V CR2032
flat lithium battery (not included). Insert the battery in the battery
compartment, making certain that the positive and negative (+ and -)
battery terminals are attached to the corresponding terminals on the
plate in the battery compartment. If an AC power failure occurs, the
clock automatically switches to the battery power supply, the clock and
timer memory continue running. When the AC power resumes, the clock
switches back to AC again.
GETTING STARTED
Press the reset button (20) locates on the back of unit after AC plug in.
- The unit will display full segment for 2 seconds, then it will enter the
normal mode.
1. TIME AND CALENDAR MANUAL SETTING
A. Setting Time and Calendar – Press mode set button (5) in normal
mode and keep depress over 2 seconds to enter time set mode, after
enter the setting mode, press mode set button (5) to change the
mode cycle as follows :
Normal → Year → Month → Day → 12/24 H → RTC Hour → RTC
Min → Normal
Action (during data adjustment) :
- Press <</Year-Month-Day button (3) to adjust data backward.
- Press >>/DST button (4) to adjust data forward.
- Keep depress << or >> button for 2 seconds to enable auto forward.
B. Setting Alarm 1 and Alarm 2 – Press alarm set button (2) during
normal mode and keep depress over 2 seconds to enter alarm
set mode, after enter the setting mode, press alarm set button (2) to