OK. ORD 300 Manual De Instrucciones página 20

EN
AUDIO INPUT AUX IN
Attention:
Before you connect your external player (for example an MP3 player), refer to its user
guide regarding safety instructions and use with other devices.
Open the AUX IN compartment and take out the audio cable.
1.
2. Insert the jack into the headphone output or LINE OUT output of the external
playback device.
3. If desired, stow the external playback device in the AUX IN compartment and close
it again.
Note:
• Disconnect the Bluetooth® connection with audio sources before connecting an
external device via AUX IN.
• Switch the external player on and turn its volume to zero.
• Turn the speaker system on and regulate the volumes of both devices.
• If you would like to connect an external device with this product, a good quality
shielded cable must be used, which ensures the electromagnetic compatibility of the
product and the used cable as a whole.
GENERAL SETTING
Sender information
Briefly press the INFO/MENU button each time to display various information such as
Radio Text, station name, time, etc.
CLEANING AND CARE
• Unplug the adaptor from the socket before cleaning the unit.
• Attention! Do not let water penetrate into the unit.
• Clean the housing with a lightly dampened cloth.
• Do not use sharp, scouring or aggressive cleaners.
• Do not use chemicals (such as gasoline or alcohol) to clean the housing.
TROUBLESHOOTING
If there are any problems during operation, please refer to the following table.
If problems cannot be solved as indicated under Solution, please contact your
manufacturer.
Problem
Product does not function
No Sound
Poor radio reception
quality
IM_ORD300_A5_201202_V04_HR.indb 20 IM_ORD300_A5_201202_V04_HR.indb 20
20
Possible causes
Interrupted power supply
Volume is very low
Poor radio reception
Solution
Check the power supply or
change batteries
Adjust the volume
Place the product to
another place and adjust
the antenna again.
2/12/2020 2:21 PM 2/12/2020 2:21 PM