Publicidad
Idiomas disponibles
Idiomas disponibles
MOUNTING
The RNK-22 transmitter is mounted on walls by means of a double-adhesive tape or wall
plugs included in the kit with a transmitter. During mounting it is important to protect the
transmitter from water and operation in humid conditions. The ambient temperature during
installation should be from -10 do +55°C.
While mounting the transmitter with a built-in temperature sensor, it is important to
pay attention not to mount the transmitter in direct sunshine or frequent air move-
ments. It must be installed at a proper height.
Mounting by means of wall plugs:
1. Remove the button - to do it press the button on one side, and on the other side put a
screwdriver into a slot and lift up the button.
2. Find a place on the wall to mount the transmitter, make two holes corresponding mounting
holes of the transmitter's base.
3. Set wall plugs in the holes.
4. Fix the base by means of screws into wall plugs.
5. Place the button again.
27 mm
Caution:
● it is best to use 5x(3x30) mm wall plugs,
● optimum double-adhesive tape thickness is 1,2 mm,
● wall plugs and double-adhesive tape are included in the kit with a transmitter.
45 mm
23 mm
Suggested places
for the double-adhesive
tape
Publicidad
