Zamel exta life RNK-22 Manual Del Usuario página 16

Switching on the temperature sensor
In order to switch on the temperature sensor, carry out the
following:
1. Take the battery out of a transmitter.
2. Press button "1" of the transmitter.
3. While pressing button "1" insert the battery into the
transmitter.
4. Release button "1" of the transmitter.
5. Temperature sensor is switched on.
ADDING TEMPERATURE SENSOR IN EXTA LIFE SYSTEM
Adding a sensor into the EXTA LIFE system requires the connection of the EXTA LIFE con-
troller and the installation of extalife application in a mobile device.
In order to pair a sensor with a controller the fol-
lowing is required:
1. Start extalife application.
2. Enter the "Device" screen.
3. Choose the "Sensors" tab.
4. Enter the search screen by pressing the "+" but-
ton.
5. In time shorter than 60 seconds it is required
to press any button of the transmitter 5 times.
After that wait for a few seconds.
6. The temperature sensor is registered on the
sensor list waiting for pairing with the controller.
7. Before another 60 seconds elapse, the next
temperature sensors can be registered or the
search process can be stopped by pressing the
"Stop" button.
8. After the sensor search is finished, it is required
to mark the sensors we want to add in the con-
troller and press the "Pair" button.
9. After the above procedure is finished the sen-
sor is visible in the system and it can show the
temperature registered during the pairing pro-
cess. It is possible to assign a name to the sen-
sor, an icon and use it in the mobile application.
Caution: The application temperature is updated each time we enter the screen by
the sensor or each time we refresh the screen manually (drag the screen downward).