Publicidad
Idiomas disponibles
Idiomas disponibles
3.2 FILLING THE WATER TRAY.
The table saws, models MAGNUM 700L and
1000L are designed to work with diamond disks cooled
by water. Therefore, an important part of the frame is
a tray intended to serve as the cooling water deposit
pumped in a closed circuit on the disk blade.
WARNING: Before plugging the machine to
the electricity and starting to cut, make sure
that
the
water
completely cover the pump.
During cutting operations, a large amount of
dirt is accumulated in the tray. Thus, you have to
change the water as often as necessary to ensure the
smooth functioning of the pump and the perfect cooling
of the disk. You will find a plug on the water tray.
Remove it to empty the tray and plug it back in before
refilling the tray with clean water.
To isolate the pump from dirt as much as
possible and prevent mud would block it, it must be
placed in the support designed for this purpose.
The water tray has a plug (T, Fig. 3). Open it
to easily empty the tray after each work.
WARNING: The water pump needs to be
totally covered by water. Water is crucial for
the cooling of the blade.
4. SAFETY RECOMMENDATIONS.
Table saws, models MAGNUM 700L and 1000L are only to be used by someone who is familiar with its
functioning.
•
Before starting up the machine please read the instructions and make sure safety norms are respected. Learn
how to stop the machine in a fast and safe way.
•
Place the machine on a flat surface. Connect the machine to the power supply only when you are sure of its
stability.
•
Before starting to work, make sure that your machine is in perfect state and fully operational.
•
Do not start the machine if you have assembled all the safeguards that come with the machine.
•
Use the horizontal and vertical rulers supplied to firmly hold the piece to cut, so it does not move when
cutting.
•
It is recommended to use safety goggles, safety boots, gloves etc. Always use approved materials.
•
Always use Individual Protection Equipment (IPE) in accordance with the type of work you are doing.
•
Keep strangers away from the machine working area.
•
Work clothes are not supposed to have loose articles that can cling into movable parts of the machine.
•
When you have to move the machine, unplug the electricity cables and block the moving parts of the
machine.
•
Use the blades indicated in this manual. Replace the disc immediately if it becomes deformed or damaged, as
it may cause an accident.
•
Never use the machine for purposes other than those it has been designed for.
VERY IMPORTANT: Always use earth plug before starting-up the machine.
tray
is
full
enough
to
7
ENGLISH
Publicidad
