Publicidad
Idiomas disponibles
Idiomas disponibles
•
Use normalised extension cables.
•
Make sure the feeding voltage is in accordance with the voltage indicated in the sticker on the machine.
•
Make sure that the extension cables are not in contact with points of high temperature, oil, water, sharp
edges. Also avoid trampling or crushing the cables by passing vehicles and do not put any objects on the
machine.
•
Do not use high pressure water to clean circuits or electrical elements.
•
Replace immediately any damaged or partially severed electric cable.
•
Keep the elements of protection and safety close to you.
•
Unplug the machine before manipulating inside its mechanical or electrical elements. Always refrain to do it
when the motor is on.
WARNING: Read carefully the instructions mentioned in the present manual and make sure all safety and
prevention norms of the worksite are respected.
SIMA, S.A. will not be held liable for consequential or other damages in relation to the table saws MAGNUM 700L and
1000L.
5. PLUGGING THE MACHINE & ADJUSTING THE BLADE ROTATION SENSE.
Upon receipt of the machine, make sure the network electrical tension is adequate before plugging
the machine.
The electrical tension is to be found on the voltage indication next to the switch of the machine.
WARNING: Never plug the machine to electricity in case the network power tension is not the
adequate with the engine would undergo irreparable damages.
The machines are to be connected only with a normalised switch board according to its
motorization and voltage that has a residual-current device at 30 mA and magneto-thermal.
Three-phase motor at 7,5 y 5.5 Kw at 400V. 20 A Magneto-thermal.
MAGNUM 700L and 1000L models with a three-phase motor leave the factory prepared for 400V,
these technical information can be found on a sticker.
Once you have gone through the steps described above, and before placing the blade and
operating the motor, please check and adjust clockwise the motor shaft rotation, by switching the
machine on to the power supply. If necessary and with three-phase motors, you can change the rotation
direction swapping the two-phase wires in the aerial or in the peg of the feeding extension cable.
If necessary, you will have to swap the conducting cables to change the rotation sense of the
blade. Do this only with the machine unplugged from electricity.
The water pump is connected in parallel with the motor so that it starts only when the motor
starts.
WARNING: Never manipulate power supply cables or any other electrical equipment on the
machine before you unplug the machine from electricity.
Once the blade rotation sense has been adjusted, you can mount the cutting blade.
8
ENGLISH
Publicidad
