Publicidad
Idiomas disponibles
Idiomas disponibles
After "OK" is pressed, the keyboard disappears from the screen.
Repeat the above steps, if necessary, for the other input field.
Pressing "Start"
now starts the heating process and the
heating data are coupled to the entered data, Operator name and
Workpiece data.
When the process has been completed, an overview mask with all
the heating data is displayed.
At this moment the heating data can be exported to a USB data
carrier. Press the "Export log"
Schaeffler Technologies
button.
The screen below appears as a sign that the export of the log file
has been successful. Press "OK" to confirm the message and to
clear the message from the screen.
The file is now stored as a .CSV file (comma separated variables)
that can be imported, for example, into Microsoft Excel for
processing as a report.
Section 10.6 describes how the file can be imported into Excel.
It is not necessary to export the log files directly after each
heating cycle.
The files are stored on the generator and can be later selected
from a list for viewing and/or for export to a USB data carrier.
Further information on log files can be sound in section 10.
9.4 Target button
In all heating modes, a "target" button
top right-hand corner during heating.
Pressing this button during heating allows the desired
temperature or time to be adjusted up or down without having to
stop the process.
Adjustment can be made in steps of 5°C or 5 seconds, depending
on which heating mode is currently active.
Proceed as follows:
During heating, press "target"
following screen is displayed.
is displayed in the
. In temperature mode, the
17
EN
DE
ES
FR
NL
Publicidad
