Haojue TZ150S 2015 Manual De Uso página 94

Engine oil change
Replace the engine oil with new oil after the engine is in a
hot state to completely drain the original engine oil. Steps
for engine oil replacement.
1. Stop the engine and support it on flat ground with the
help of the main stand.
2. Remove the engine oil dipstick 1.
3. Place a drain pan below the engine. Dismantle the
drain plug 2 and its washer to drain the original
engine oil.
4. After draining all the engine oil, install the drain plug
2 and its washer.
5. Fill 1000 milliliter of new engine oil into the engine via
the oil filling port of the dipstick.
6. Install engine oil the dipstick again 1.
7. Start the engine and have it run for several minutes.
8. Stop the engine and inspect the engine oil with
the dipstick several minutes later.
level should be between the UPPER LEVEL and the
LOWER LEVEL.
Haojue TZ150S 99011H36640H000 V01 ES+EN 2015-1-17
Engine oil strainer
Regularly replace the engine oil strainer as instructed in
the "Table of Regular Maintenance". The replacing steps
are as follows.
The engine oil
1. Completely drain the original engine oil as instructed
2. Dismantle the engine oil strainer cap 1 and take out
34
https://www.motomanuals.net/
Haojue TZ150S 99011H36640H000 V01 ES+EN 2015-1-17
BCAUTION
Use the engine oil recommended
"Instructions for use of fuel and engine oi".
BCAUTION
Carefully inspect whether the engine parts that
have been dismantled and installed again suffer
any oil leakage.
BCAUTION
It is suggested to replace the seal rings when the
engine oil filter element is replaced.
in section "Engine oil replacement".
the spring 3 and the engine oil strainer 4.
(93)
in the
EN
(93)