Publicidad
Idiomas disponibles
Idiomas disponibles
(94)
Haojue TZ150S 99011H36640H000 V01 ES+EN 2015-1-17
NOTE: Do not lose the seal ring 2 on the engine oil
strainer cap.
3. Clean and inspect the engine oil strainer and, if it is
damaged, replace it.
4. Install the spring, the engine oil strainer and the engine
oil strainer cap.
NOTE: Do not lose the seal ring 2 on the engine oil
strainer cap.
5. Add the specified new engine oil into the engine as
instructed in section "Engine oil replacement".
BCAUTION
Carefully inspect whether the engine parts that
have been dismantled and installed again suffer
any oil leakage.
BCAUTION
EN
It is suggested to replace the seal rings when the
engine oil filter element is replaced.
CLUTCH
(94)
Haojue TZ150S 99011H36640H000 V01 ES+EN 2015-1-17
Method to inspect the clutch cable gap 4: remove the
rubber bush 1 along the clutch cable, operate the clutch
handle and make sure there is a gap of 4mm before there
is an apparent resistance. If the gap is insufficient, adjust
it with the method below.
1. Remove the rubber bush 1 along the clutch cable,
2. Turn the adjusting screw 3 clockwise till the end.
3. Loosen the lock nut 5, adjust the nut 6 along
4. Do fine adjustment through the adjusting screw 3.
5. Firmly lock the nut 2 and 5, and then mount the
CARBURETOR
Stable carbureting evaporation is the most fundamental
requirement for the carburetor.
evaporation has been accurately set in the factory. Please
do not change its setup. You only need to pay attention to
35
https://www.motomanuals.net/
loosen the nut 2.
the front-back direction, operate the clutch lever and
adjust the clutch cable gap 4 to be about 4mm.
rubber bushes 1.
BCAUTION
Excessive clutch cable play can easily result in
wear and faults in the clutch and the gear shift
lever. If the clutch cable gap is not correct, or the
clutch is slipping or accelerating weakly, adjust the
cable on time.
The carbureting
Publicidad
