Metra 99-7636B Instrucciones De Instalación página 3

DASH DISASSEMBLY
5. Remove (1) Phillips screw securing the
passenger side a/c vent, then remove
the vent. (Figure E)
6. Remove (1) Phillips screw securing the
dash panel above the glovebox, then
unclip and remove the panel. (Figure F)
7. Remove (4) Phillips screw securing the
radio. Slide the radio out then unclip and
remove the radio. (Figure G)
Continue to Kit Assembly
(CONT.)
(Figure E)
(Figure F)
unit
(Figure G)
KIT ASSEMBLY
1. Secure the pocket to the radio brackets
using the (4) #8 x 3/8" Phillips screws
provided. (Figure A)
2. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
3. Slide the radio into the bracket/pocket
assembly, then secure it using the screws
supplied with the radio. (Figure B)
4. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to the
radio. Metra recommends using the proper
mating adapter from Metra and/or Axxess.
Test the radio for proper operation.
5. Secure the radio assembly to the dash
using the factory screws.
6. Clip the radio trim panel to the dash.
7. Reassemble the dash in reverse order of
disassembly to complete the installation.
(Figure A)
(Figure B)
REV. 4/18/2022 INST99-7636B
3