Publicidad
Step 8
You may need someone's help in this step to keep pressure on the
å
LONG SLAT.
Turn fi ve BLACK 9/16" FLAT HEAD SCREWS (32S) into the LOWER
å
PANEL (C) until the shoulders of the SCREWS rest on the surface of
the LOWER PANEL.
NOTE: Do not overtighten the SCREWS.
å
Slide the remaining LONG SLAT (E) onto the LOWER PANEL (C).
å
Line up the groove in the LONG SLAT over the heads of the
SCREWS in the LOWER PANEL. The LONG SLAT should rest
against the LEFT MOLDING (H).
NOTE: If the SLAT comes up off of the SCREWS, remove it and
å
slide it on again.
H
Shoulder
Apply pressure with your hands as
you guide the LONG SLAT over the
SCREWS and onto the LOWER PANEL.
Page 12
C
419905
BLACK 9/16" FLAT HEAD SCREW
(5 used in this step)
E
www.sauder.com/services
32S
Publicidad
