Keysight U1253B Guía Del Usuario Y Servicios página 77

2 Making Measurements
Measuring Temperature
Do not bend the thermocouple leads at sharp angles. Repeated bending
CAUTION
over a period of time can result in the leads breaking.
The bead-type thermocouple probe is suitable for measuring temperatures from
–20 °C to 200 °C in PTFE-compatible environments. Do not use the thermocouple
probe beyond the recommended operating range. Do not immerse this
thermocouple probe in any liquid. Use a thermocouple probe designed for each
specific application — an immersion probe for liquid or gel, and an air probe for air
measurement.
Set up the multimeter to measure temperature as shown in
observe the following steps:
1 Press
2 Connect the miniture thermal probe into the non-compensation transfer
3 For best performance, place the meter in the operating environment for at
4 Clean the surface to be measured and ensure that the probe is securely
5 When measuring above ambient temperatures, move the thermocouple along
6 When measuring below ambient temperatures, move the thermocouple along
7 For quick measurement, use the 0 °C compensation to view the temperature
76
to select temperature measurement.
adapter as shown in
adapter into the meter input terminals as shown in
least one hour to stabilize the unit to environment temperatures.
touching the surface. Remember to disable the applied power.
the surface until you get the highest temperature reading.
the surface until you get the lowest temperature reading.
variation of the thermocouple sensor. The 0 °C compensation assists you in
measuring relative temperature immediately.
Figure 2-15. Then connect the thermal probe with the
Keysight U1253B User's and Service Guide
Figure 2-17 or
Figure 2-16.