Create STONE 3IN1 STUDIO Manual Del Usuario página 8

1. Choose the cooking plate you are going to use and insert it into the sandwich maker.
2. Plug the sandwich maker into the power outlet and press the on/off button on the side of
the product. The light will turn on and the sandwich maker will begin to heat.
3. After 5 minutes the light will turn off to indicate that the sandwich maker has reached the
maximum cooking temperature.
Note: The cooking surface will be hot, be careful.
4. Place the ingredients on the plate, if you wish you can add a little oil depending on what
you are going to cook or your personal preference.
5. Close the lid and lock the handle to cook the ingredients.
ATTENTION. In the first uses this product may give off a slight odor and some smoke. Do not
worry, it is something temporary and harmless. Make sure there is enough ventilation.
6. After 3 minutes the light will turn on and off to indicate that the sandwich maker is hold-
ing at cooking temperature. The sandwich maker can continue cooking depending on
your personal tastes or the recipe you are going to prepare.
7. Take the food out when it has reached your chosen level of doneness.
Note: Be careful when you take the food out as it will be hot. Wait a few minutes for it to
cool down a bit before eating it.
8. Press the on/off button to turn off the sandwich maker. Unplug the power cord after cook-
ing and allow the sandwich maker to cool down before moving, cleaning, or storing.
1. Before replacing the plates, make sure they are completely cool.
2. Press the plate release buttons.
3. Once the tabs of the plate are pressed, they will be released and you will be able to ex-
tract it correctly.
4. When inserting the desired plates, make sure they are properly installed and locked.
• Unplug the appliance after use and wait for it to cool down, then wipe the inside of the
cooking tray with a damp cloth and make sure the appliance is left clean. You can also
remove the cooking plate once it cools down to clean it.
• You can also clean the outer surface with a damp cloth.
• Do not rinse the sandwich maker by immersing it in water to avoid electrical currents or
any other problem.
In compliance with Directives: 2012/19/EU and 2015/863/EU on the restriction of the use of dangerous substances in elec-
tric and electronic equipment as well as their waste disposal. The symbol with the crossed dustbin shown on the package
indicates that the product at the end of its service life shall be collected as separate waste. Therefore, any products that
have reached the end of their useful life must be given to waste disposal centres specialising in separate collection of
waste electrical and electronic equipment, or given back to the retailer at the time of purchasing new similar equipment,
on a one for one basis. The adequate separate collection for the subsequent start-up of the equipment sent to be recycled,
treated and disposed of in an environmentally compatible way contributes to preventing possible negative effects on the
environment and health and optimises the recycling and reuse of components making up the apparatus. Abusive disposal
of the product by the user involves application of the administrative sanctions according to the laws.
E NGL I SH
8
INSTRUCTIONS FOR USE
PLATE EXCHANGE
CLEANING AND MAINTENANCE