Publicidad
Idiomas disponibles
Idiomas disponibles
BATTERY REPLACEMENT AND DISPOSAL
This unit contains a sealed non-spillable lead-acid battery.
This battery must be recycled. Consult your state or local
government concerning regulations for proper disposal.
The battery inside this product is a sealed lead-acid battery. It is required by law to
be removed and recycled or disposed of properly. While there are federal regulations
that must be complied with throughout the United States, your individual state or local
governments may have additional regulations to be followed.
When the battery in this product is in need of replacement, remove it according to the
instructions provided below and take it to your local recycling center for proper recycling
or disposal. If you don't have a local recycling center that handles sealed lead-acid
batteries, contact your local environmental agency for instructions.
Removal instructions:
Begin by making sure that both clamps are securely placed in a position that ensures
they will not come into contact with each other.
1. Lay the Jump-N-Carry down on its front. On the back of the unit, locate the 8
screws that join the back plate to the case.
2. Remove the screws, then lift off the back plate.
3. On the top of the battery are two terminals, each with wires connected to them.
Disconnect these wires from the battery by removing the bolts that hold them to
the battery terminals. To prevent accidental arcing, be careful not to touch both
battery terminals with the tools being used to remove the bolts.
4. Lift the battery out of the case.
After fully charging the battery (see "Recharging" section), with the unit connected in
12V mode, apply a 100 amp load to the unit for a period of 6 seconds, while monitoring
the battery voltage. The battery is good if the voltage is 9.5 Vdc or higher.
The Jump-N-Carry may be stored virtually anywhere, and in any position. It is best to
ensure that it is stored in a safe, secure location that is not exposed to temperature
extremes. Please remember to charge it every 90 days when not in use, but more
frequently if it is stored in very cold (<40°F) or very hot (>90°F) conditions.
Take precautions to ensure that the positive and negative clamps do not come into
contact with each other or a common metal surface. In addition, during storage,
disconnect the voltage selector, rendering the unit OFF. We recommend storing the
Jump-N-Carry in the box in which it was originally received. Always be sure to re-wrap
cables and re-holster clamps after each use and prior to storage.
TESTING THE BATTERY
STORAGE
10
Pb
Publicidad
