Corega BAR-SD Manual De Instrucciones página 22

SNMP
• Enable SNMP : You must check either Local or Remote or both to enable the SNMP function. If Local is checked, this device will response request from LAN. If Remote
is checked, this device will response request from WAN.
Routing
Only users with an excellent understanding of router protocols should attempt to change settings in this area. This may be required if you have more than one router on
your LAN.
Enter the information on the static routes in the following fields
• Destination IP Address: Enter the IP Address of the destination LAN that the immediate LAN is to communicate with.
• Subnet Mask: Enter the Subnet Mask of the destination LAN that the immediate LAN is to communicate with.
• Gateway: Enter the IP Address of the router that forwards data packets to the destination LAN.
20