Corega BAR-SD Manual De Instrucciones página 8

Computer System Requirements and Setup
To connect to the internet, an external ADSL or Cable modem and an internet access account from an ISP are required. In order to operate with the Corega BAR-SD Router,
each PC that is to be connected to the Corega BAR-SD Router should have the following installed:
• Ethernet NIC (Network Interface Card: a 10Base-T or 10/100Base-T/TX Ethernet card), or wireless client card for wireless connection.
• System OS: Windows 95, Windows 98, Windows NT4.0, or Windows 2000, or XP.
• TCP/IP network protocol.
• Web browser, such as Microsoft Internet Explorer 4.0 or later, or Netscape Navigator 4.0 or later.
Note! If your computer does not have TCP/IP installed, please read Appendix A before continuing with the installation.
Installing the Corega BAR-SD Router
To configure the Corega BAR-SD Router, you should connect a computer to the router through one of the LAN ports.
1. Disconnect the PC from a functioning broadband connection.
2. Connect the WAN port of the router to the ADSL/Cable modem using the original cable.
3. Connect the computer to any one of the Corega BAR-SD Router LAN ports using the supplied Ethernet Cable.
4. Connect the power adapter to the Corega BAR-SD Router.
5. In the majority of cases, the PC will require a Dynamic IP address, which will be automatically allocated by the Corega BAR-SD Router. To access any of the setup
screens of the router – point a browser at 192.168.123.254. If the router does not respond, check the IP configuration of the PC – see Appendix A.
6