Publicidad
Idiomas disponibles
Idiomas disponibles
Heater Control Panel
The following switches are located at back of the heater.
Insert plug into mains socket
Select the desired functions:
Switch 2 (O/I ) ：Switchs on/off electricity supply to the heater and flame effect
⚫
⚫
Note: This switch must be in the ON (I) position for heater to operate with or without
heat
Switch 3 ( I ) ：Switchs on/off 1000W heat output
⚫
Switch 4 ( II ) ：Switchs on/off 2000W heat output with switch 3 together.
⚫
Note: The flame effect can be operated with or without heat.
Rotate thermostat knob (1) clockwise or anti-clockwise to increase or decrease desired
room temperature setting.
Safety Cut-Off
This appliance is fitted with a safety cut-off which will operate if the heater overheats (e.g.
Due to blocked air vents). For safety reasons, the heater will NOT automatically reset.
To reset the appliance, disconnect the appliance from the mains supply for at least 15
minutes. Reconnect the supply to the mains and switch on the appliance.
Maintenance
Before cleaning or maintenance operation, switch off and unplug the appliance. Ensure it is
perfectly cooled.
To remove the dust, wipe the appliance with a cloth
Never use abrasives or detergents
Bulb Replacement
This product does not use a standard bulb for its flame effect. The appliance uses an
electronically controlled LED system to create the effect, therefor no parts need to be
2
3
4
1
-3-
Publicidad
