Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
TROUBLESHOOTING
TROUBLESHOOTING TABLE
Use this table to see possible solutions for possible problems with the pole saw. If these
suggestions do not solve the problem, see Warranty.
SYMPTOM
Battery discharged
Battery pack not fully
inserted
Battery contacts dirty
Motor does
not run or runs
intermittently
Battery pack cold
Overheating of motor
Defective power switch
Unit will not blow
Blocked tube
14
POSSIBLE CAUSE
RECOMMENDED ACTIONS
Charge the battery.
Press the battery pack into the battery port
until it clicks into place.
Remove the battery pack, remove debris
from the battery port, and then clean the
contacts with a clean, dry cloth.
Allow the battery pack to warm to the
minimum operating temperature of 32°F
(0°C).
Let the motor cool down.
Contact Senix customer service at 1-800-
261-3981.
Clear the blockage.
WWW.SENIXTOOLS.COM
Publicidad
