Publicidad
Idiomas disponibles
Idiomas disponibles
PROGRAMMING
Programming the wall transmitter - JMWS-1 / JMWST-5
Each keystroke must be executed within 4 seconds!
Otherwise, the system automatically exits the programming mode.
1.
First select the desired channel by pressing the K1 or K2 key. (not applicable for JMWS-1)
2.
The channel highlighted in black is selected (JMWST-5 only).
ATTENTION: If all channels (1-5) are selected (highlighted in black), group control is activated.
The group control can NOT be taught-in as a separate channel!
3.
Set the receiver (motor/external receiver) to programming mode according to the instructions.
4.
Press the P2 programming key (back) 2 times.
5.
Press the UP button 1 x. The motor (shutter) briefly moves UP/DOWN and/or the receiver beeps*.
OK! Programming successfully carried out!
6.
To program additional channels (JMWST-5), start from the beginning.
*The frequency of the beeps or the response of the motor/roller shutter depends on the receiver.
Please refer to the corresponding instructions of the respective receiver / motor.
Then check the function by pressing the UP / STOP / DOWN keys.
If the direction of rotation of the motor is reversed (roller shutter/motor moves downwards when the UP key is pressed), plea-
se start from the beginning and press the DOWN key instead of the UP key after the P2 key!
This will change the direction of rotation of the motor.
To program several transmitters/channels for ONE motor/receiver, the „Add handheld transmitter" function must be used
(depending on the receiver model). Add handheld transmitter" function must be used (depending on the receiver model),
since - e.g. for radio motors - only one transmitter can be programmed directly into the receiver. Please observe the corres-
ponding instructions of the respective receiver/motor!
22
1 2 3 4 5
Time set / channel selection key K1
Mode button
Time set / channel selection key K2
Up
Stop
Down
Programming key P2
Publicidad
