Publicidad
Idiomas disponibles
Idiomas disponibles
Add wall transmitter or handheld transmitter
1 2 3 4 5
Select an already programmed channel on an ALREADY PROGRAMMED station by pressing the K1 or K2 key.
1.
programmed channel (not applicable for JMWS-1).
2.
Then, on the station to be programmed NEW, select the channel you want to add by pressing the K1 or K2 key,
that you want to add (the channel highlighted in black is selected).
3.
Press the P2 programming button (back) 2 times on the already programmed transmitter.
4.
Then press the P2 programming button (back) 1 x on the new transmitter to be programmed.
5.
The motor (shutter) moves briefly UP/DOWN and/or the receiver beeps*.
OK - handheld transmitter is added!
*The frequency of the beeps or the reaction of the motor / shutter depends on the receiver.
Please refer to the corresponding instructions of the respective receiver / motor.
PROGRAMMING
Time set / channel selection key K1
Mode button
Time set / channel selection key K2
Up
Stop
Down
P2 button
23
Publicidad
