Descargar Imprimir esta página

Medline MDS7001B Manual Del Usuario página 14

Publicidad

Idiomas disponibles

Idiomas disponibles

To Mitigate Possible Interference
1. The range between the device and BT monitor should
be reasonably close, from 1 meter to 10 meters.
Please ensure no obstacles between the device
and the BT monitor to help obtain quality connection
and to lower the RF output range.
2. To avoid interference, other electronic devices
(particularly those with wireless transmission/
Transmitter) should be kept at least 1 meter away
from the monitor.
Attaching the Cuff
1. Remove all accessories (watch, bracelet, etc) from your
non-dominant arm. If your physician has diagnosed you
with poor circulation in that arm, use the other one.
2. Cuff must be used only over bare skin. Make sure blood
flow in arm is not restricted by clothing.
3. Apply cuff to the arm, user's palm up, and the red mark
on the cuff is closest to the elbow, lined up with the
brachial artery.
4. Position the edge of the cuff about 1-2 cm from elbow.
5. Fasten the cuff around your arm, leaving no extra room
between the cuff and your skin. If the cuff is too loose,
the measurement will not be accurate.
6. Sit comfortably with your tested arm resting on a flat
surface. Place your elbow on a table so that the cuff is
at the same level as your heart.
24
Helpful tips
Rest for 5 minutes before first measurement.
Wait at least 3 minutes between measurements.
This allows your blood circulation to recover.
The user must relax as much as possible;
do not move or talk during the measurement.
Take the measurement in a silent room.
The cuff should be placed and remain at the
same level of the heart.
Sit comfortably. Do not cross your legs and keep
your feet flat on the ground. Keep your back against
the backrest of the chair.
For a meaningful comparison,
try to measure under similar conditions.
For example, take daily measurements
at approximately the same time,
on the same arm,
or as directed
by a physician.
MEASUREMENT
Starting the Measurement
1. Turn the monitor ON using the switch on top
of the unit. If using the Medline Health app,
make sure the application is running on your
smart device.
25

Publicidad

loading