Publicidad
Idiomas disponibles
Idiomas disponibles
REMOTE CONTROL
REMOTE FUNCTIONS
1. Press
to power unit ON or OFF.
2. Select desired speed setting by pressing
or
button.
3. Press
to change from direct airflow to exhaust. Press the
button again to change from exhaust to direct airflow.
4. Press to activate AUTO MODE. The icon will turn green to
indicate AUTO MODE is activated.
• Press
or
button to set your ideal temperature, holding
either button for 3 seconds will allow for quick temperature
adjustment up or down by 5 degrees per second.
• While in this adjustment mode, the temperature display will
momentarily flash and then return to display the current indoor
room temperature.
• A single press of the button, when AUTO MODE is activated,
will change display from room temp back to SET TEMP flashing if
adjustments are needed.
• Press the button twice to deactivate AUTO MODE. The icon
will turn white to indicate AUTO MODE is deactivated.
Note: The remote requires a line-of-sight path to allow for the signal
to be received by the product. Position the product so the receiver
lens (located near near the control panel) is visible from the remote
control.
12 English
REMOTE CONTROL
BATTERY REPLACEMENT
Screwdriver required.
Your circulator remote includes (1) coin style 3V CR2032 battery. Battery comes pre-installed. Remove battery pull tab before first use. The pre-
installed battery has a 1 year life expectancy (dependent on usage) after the tab has been pulled from the remote.
1. For battery replacement, the remote requires one coin style 3V CR2032 battery. Always use the correct size and grade of battery for this
product.
2. To replace battery, open battery door on the back side of the remote control (you will need to loosen the small screw on door using a #1 Phillips
screwdriver). If necessary, clean the battery contacts and also those of the device prior to battery installation. Remove any plastic protection
from the battery and place it in the remote with the + side facing out. Ensure the battery is installed correctly with regard to polarity. Replace
the battery door and screw.
Note: Remove battery from the remote control when not in use for an extended period of time and always remove dead battery immediately and
replace with fresh. Do not store dead battery in remote.
WARNING: This product contains a button battery. If swallowed,
it could cause severe injury or death in just 2 hours. Seek medical
attention immediately.
13
English
Publicidad
