Troubleshooting; Disposal - Dometic GROUP WAECO CoolFreeze CDF18 Instrucciones De Uso

CoolFreeze
9

Troubleshooting

Fault
Device does not
function, LED does
not glow.
The device does not
cool (plug is inserted,
"POWER" LED is lit).
The device does not
cool (plug is inserted,
"ERROR" LED
flashes).
When operating from
the 12/24-V socket
(cigarette lighter):
The ignition is on
and the device is not
working and the LED
is not lit.
Pull the plug out of the
socket and make the
following checks.
"ERROR" LED flashes
for longer than
2 minutes, as follows:
3 flashes, pause,
3 flashes, pause, ...
10

Disposal

➤ Place the packaging material in the appropriate recycling waste bins
wherever possible.
If you wish to finally dispose of the product, ask your local recycling
M
centre or specialist dealer for details about how to do this in
accordance with the applicable disposal regulations.
EN
Possible cause
There is no voltage
present in the 12/24 V
socket (cigarette lighter)
in your vehicle.
No voltage present in
the AC voltage socket.
Defective compressor.
Battery voltage is too
low.
The cigarette lighter
socket is dirty. This
results in a poor electrical
contact.
The fuse of the 12/24 V
plug has blown.
The vehicle fuse has
blown.
Device is defective.
Suggested remedy
The ignition must be switched on in most
vehicles to apply current to the cigarette
lighter.
Try using another plug socket.
This can only be repaired by an
authorised customer services unit.
Test the battery and charge it as needed.
If the plug of your cooler becomes very
warm in the cigarette lighter socket,
either the lighter socket must be cleaned
or the plug has not been assembled
correctly.
Replace the fuse (5 A) in the cigarette
lighter plug, see chapter "Replacing the
plug fuse (12/24 V)" on page 37.
Replace the vehicle's 12/24 V socket fuse
(usually 15 A). Please refer to your
vehicle's operating manual.
This can only be repaired by an author-
ised customer services unit.
Troubleshooting
39