Publicidad
Idiomas disponibles
Idiomas disponibles
- After properly installing the gate opener, adjust the electronic clutch so that the
strength necessary to a complete gate maneuver is minimum when the device is both
opening and closing.
Instructions:
1.
The gate must be still;
2. Close the 'JPROG' jumper;
3. Press and release the 'FORCE' button on the board (once) to show the current
adjustment;
4. Press and release the 'FORCE' button as many times as necessary until one rea-
ches the desired adjustment;
5. In order to finish, open the 'JPROG' jumper.
LED indications:
•
'N1' flashing = Off.
•
'N1' lit = Minimum.
...
•
'N8' lit = Maximum.
SEMI-AUTOMATIC / AUTOMATIC MODE (PAUSE TIME)
It is the time adjustment for the automatic closing when the gate reaches the opening
limit switch (LSO) or the opening stop, indicating the limit of the opening maneuver.
Instructions:
1.
The gate must be still;
2. Close the 'JPROG' jumper;
3. Press and release the 'PAUSE TIME' button on the board (once) to show the cur-
rent adjustment;
4. Press and release the 'PAUSE TIME' button as many times as necessary until one
reaches the desired adjustment;
5. In order to finish, open the 'JPROG' jumper.
LED indications:
•
'N1 flashing = Semi-automatic.
•
'N1 lit = 5 seconds.
•
'N2' lit = 10 seconds.
•
'N3' lit = 30 seconds.
•
'N4' lit = 60 seconds.
•
'N5' lit = 90 seconds.
•
'N6' lit = 120 seconds.
•
'N7' lit = 180 seconds.
•
'N8' lit = 240 seconds.
OPENING RAMP
It is the distance between the opening mechanical stop and the point of the path
where the electronic board enters torque control mode in order to decrease the speed
of the gate and turn the opener off on the acquired path, i.e., the distance in which the
opener starts decelerating when opening the gate.
Instructions:
1.
The gate must be still;
2. Close the 'JPROG' jumper;
3. Press and release the 'OPEN RAMP' button on the board (once) to show the
current adjustment;
4. Press and release the 'OPEN RAMP' button as many times as necessary until one
reaches the desired adjustment;
5. In order to finish, open the 'JPROG' jumper.
28
Publicidad
