Publicidad
Idiomas disponibles
Idiomas disponibles
BRAKE
It is activated when the motor is turned off by a command, or when the opener rea-
ches the analog sensors (limit switches).
Instructions:
1.
The gate must be still;
2. Close the 'JPROG' jumper;
3. Press and release the 'BRAKE' button on the board (once) to show the current
adjustment;
4. Press and release the 'BRAKE' button as many times as necessary until one rea-
ches the desired adjustment;
5. In order to finish, open the 'JPROG' jumper.
LED indications:
•
• 'N1' flashing = Function disabled
•
• 'N1' lit = Minimum.
...
•
• 'N8' lit = Maximum.
COURTESY LIGHT TIME
It selects the time in which the 'LIGHT' output will remain activated after the gate
closes.
During the opening or closing maneuver, or when the gate is still and open, the relay
module will remain enabled. Whenever the control board finishes the closing maneu-
ver, the relay module will be disabled after the time set.
Instructions:
1.
The gate must be still;
2. Close the 'JPROG' jumper;
3. Press and release the 'LIGHT' button on the board (once) to show the current
adjustment;
4. Press and release the 'LIGHT' button as many times as necessary until one reaches
the desired adjustment;
5. In order to finish, open the 'JPROG' jumper.
LED indications:
•
'N1' flashing = Immediate shutdown.
•
'N1' lit = 5 seconds.
•
'N2' lit = 10 seconds.
•
'N3' lit = 30 seconds.
•
'N4' lit = 60 seconds.
•
'N5' lit = 90 seconds.
•
'N6' lit = 120 seconds.
•
'N7' lit = 180 seconds.
•
'N8' lit = 240 seconds.
ERASING THE ACQUIRED PATH AND RESTORING THE DEFAULT FACTORY
SETTINGS
In a single operation, it erases the path (travel) of the gate acquired (memorized) by
the control unit as well as it restores the default factory settings.
Instructions:
1.
The gate must be still.
2. Keep the 'JPROG' jumper open.
3. Press the 'SET' button on the control unit and keep it pressed; the 'SN' LED will
remain off.
30
Publicidad
