Publicidad
Idiomas disponibles
Idiomas disponibles
Features
Default Setting
When the air conditioner restarts after a
power failure, it will default to the factory
settings (AUTO mode, AUTO fan, 24°C
(76°F)). This may cause inconsistencies on
the remote control and unit panel. Use
your remote control to update the status.
Auto-Restart
In case of power failure, the system will
immediately stop. When power returns,
the Operation light on the indoor unit will
flash. To restart the unit, press the ON/OFF
button on the remote control. If the system
has an auto restart function, the unit will
restart using the same settings.
When the outdoor temperature is below
zero, the electric heating belt of the outdoor
unit chassis is used for ice melting, without
defrosting. (some models)
Louver Angle Memory Function
Some models are designed with a louver angle
memory function. When the unit restarts after a
power failure, the angle of the horizontal louvers
will automatically return to the previous position.
The angle of the horizontal louver should not be
set too small as condensation may form and drip
into the machine. To reset the louver, press the
manual button, which will reset the horizontal
louver settings.
Refrigerant Leak Detection System
The indoor unit will automatically display "EC"
or "EL0C"or ash LEDS (model dependent )
when it detects refrigerant leakage.
Page 11
Publicidad
