Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION
Before changing the lter or cleaning, turn o
•
the unit and disconnect its power supply.
When removing lter, do not touch metal
•
parts in the unit. The sharp metal edges can
cut you.
Do not use water to clean the inside of the
•
indoor unit. This can destroy insulation and
cause electrical shock.
Do not expose lter to direct sunlight when
•
drying. This can shrink the lter.
Any maintenance and cleaning of outdoor
•
unit should be performed by an authorized
dealer or a licensed service provider.
Any unit repairs should be performed by an
•
authorized dealer or a licensed service provider.
Replace internal parts
1. Pull the left and right handles of the front panel ,
pull the panel outward, and open the panel.
2. Remove the 7 screws on the face frame.
3. Buckle up the snap indicated by the arrow and
remove the face frame.
4. Replace internal parts.
5. Install the face frame and panel parts.
Page 14
Maintenance –
Long Periods of Non-Use
If you plan not to use your air conditioner for an
extended period of time, do the following:
Clean all lters
Turn o the unit and
disconnect the power
Maintenance –
Pre-Season Inspection
After long periods of non-use, or before periods
of frequent use, do the following:
Check for damaged
Clean all lters
wires
Replace batteries
Make sure nothing is blocking all air inlets
and outlets
NOTE: Do not stretch or hang objects at the air
outlet.
Do not adjust the automatic air de ector by
hand or extend your hand into the air duct.
Do not cover the air inlet and outlet of the unit
with objects.
Turn on FAN function until
unit dries out completely
Remove batteries
from remote control
Check for leaks
Publicidad
