Bosch GWX18V-10P Instrucciones De Funcionamiento Y Seguridad página 17

Installing Wheel Guards
(Type 27 and Type 41/1A
Wheel Guards)
A Type 27 guard must be
used
wheels, bonded body sanding flap discs, wire
brushes and wheels. The tool may be used
without a guard only when sanding with con-
ventional sanding discs.
To attach guard (Fig. 5):
1. Unplug tool from power source.
2. Position appropriate guard on collar mount
so arrows on guard and collar mount align
(Fig. 5).
3. Rotate wheel guard clockwise 90º until
guard clicks in place.
4. Adjust guard by depressing guard release
button and rotate to desired position.
Always position wheel guard between
operator and work piece and direct sparks
away from operator (Fig. 6).
5. Allow guard release button to click in
place.
To remove wheel guard:
1. Depress guard release button and rotate
guard until arrows on guard and collar
mount align (Fig. 5).
2. Remove guard from collar mount.
Assembly
with all grinding
Fig. 5
Fig. 6
OPERATING ZONE
-17-