Descargar Imprimir esta página

CASO DESIGN WineDeluxe WD 96 Manual Del Usuario página 38

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 79
5 Operation and Handing
DE
This chapter provides you with important notices with regard to
EN
operating the device.
FR
5.1 Operating elements
IT
ES
NL
1
2
3
RUS
1
Increase temperature
SE
(upper Zone)
2
Decrease temperature
PT
(upper Zone)
3
Display (upper Zone)
4
Increase temperature
(lower Zone)
5.1.1 Symbols shown on the control panel
ECO mode is active
Unit reduces the temperature: The symbol goes out as
soon as the unit has reached the set temperature.
Unit increases the temperature: The symbol goes out as
soon as the unit has reached the set temperature.
Door is closed
Temperature display in °C
Temperature display in °F
5.2 Operation of the appliance
PLEASE NOTE
Due to the appliance's 2-zone cooling and ventilation system,
temperature settings for each zone are independent of the
other zone.
This means that the temperature in the lower zone cannot be
set higher than the temperature in the upper zone.
When using both zones with diff erent storage temperatures
the temperature in the upper zone can thus only be lower or
the same as the temperature in the lower zone.
A large diff erence in the temperature settings for each zone
can result in higher energy consumption.
5.2.1 Switching on and off
1.
Plug the power socket into mains power.
2.
The On / Off button fl ashes.
3.
Press the On / Off button.
4.
The last selected temperature will be shown on the control
panel.
5.
To switch the appliance off , press the On / Off button until
the symbols on the control panel disappear.
5.2.2 Setting the temperature
1.
Turn the appliance on.
2.
The last selected temperature will be shown on the control
panel.
3.
Simultaneously pressing both arrow buttons allows you to
change the temperature display mode between °C and °F.
4.
The selected temperature unit is saved when the corre-
sponding symbol on the control panel stops fl ashing and is
permanently on.
5.
Use the arrow buttons to set the temperature in 1° incre-
ments from 5 °C to 20 °C (41 °F to 68 °F).
38
CASO WineDeluxe WD 96
4
5
6
7
5
Decrease temperature
(lower Zone)
6
Display (lower Zone)
7
Light control
8
On / Off
6.
The desired temperature will be stored approx. 5 seconds
after the last time you press a button and the symbol on the
control panel stops fl ashing and is permanently on.
7.
The appliance's current temperature is shown.
PLEASE NOTE
Temperature recommendations: Red wine: 12°C – 18°C and
white wine: 6°C – 10°C.
The appliance can achieve the best cooling and consumption
results at a recommended ambient temperature of 16 - 20 °C.
8
The temperature in the appliance depends on the ambient
temperature, the quantity of bottles and the chosen tempe-
rature.
Please note that your appliance is intended to cool wine.
The maximum temperature which can be achieved inside
the cooler should NOT signifi cantly exceed the ambient
temperature in the room.
5.3 Illumination
5.3.1 Setting the "ECO" mode
If you select the "ECO" mode, then the appliance's interior light
will turn off when the door is shut.
1.
Press the "Light" button.
2.
The "ECO" symbol will appear on the control panel display.
3.
Shut the door.
4.
The LED light will turn off . Next time you open the door, the
light will turn on again.
5.
To deactivate the "ECO" mode, press the "Light" button
again. The LED strips will be permanently on, also when the
door is closed.
PLEASE NOTE
The illumination will switch off after 4 hours to save energy.
5.3.2 Setting light intensity
The light intensity can be set at 4 levels. They are 25 %, 50 %,
75 % and 100 %.
1.
Turn the appliance on.
2.
The LED strips will light up.
3.
Press the "Light" button for a few seconds.
4.
The appliance will briefl y peep once.
5.
Briefl y press the "Light" button again to select the desired
lighting level (L1 - L4).
5.4 How to turn off the sound
To turn off the appliance's sound simultaneously press the "Up"
arrow button and the "Light" button. You can also use this button
combination to turn the sound back on.
5.5 Wi-Fi control
An app is available to control and programme the appliance
via Wi-Fi. To connect to the appliance simultaneously press the
"Light" and "On / Off " buttons. If you have started the „connec-
tion mode" by mistake, briefl y press the On / Off key. To use the
Wi-Fi mode download the CASO Control app to your smart-
phone or tablet. Visit our website www.casoapp.com/help for
details about the app, the range of functions and instructions
on how to install it.
6 Cleaning and Maintenance
This chapter provides you with important notices with regard to
cleaning and maintaining the device. Please observe the notices
to prevent damages due to cleaning the device incorrectly and to
ensure trouble-free operation.

Publicidad

loading

Este manual también es adecuado para:

7716