Hedson IRT-System IRT-301 Manual De Instrucciones página 5

4.4. Fit the yoke and the cassettes.
4.5. Remove the front plate by unscrewing the two screws
on the upper edge of the cassette. Carefully bend out
and lift the plate out of the groove. Thread the cable
attachment through the hole in the backpiece. Firm-
ly screw the K-device in the cassette section.Connect
the cable attachment and tighten the cable entry by
fixing the small plate over the hole. Fit the front
plate.
4.6. Set the cable in the clip above the arm when the
parallel arm is in its lower position. Install the clamp
protection using six screws.
IRT-301, 302, 230 V, 400 V, 1 Ph, 3 Ph
N.B. Attach a locking
nut inside the cassette
M10 (lock)
M10x60
Groove
Option
M12x160
5