Publicidad
Idiomas disponibles
Idiomas disponibles
To inflate vehicle and bicycle tires:
1. Place inflator evenly on flat surface.
2. Plug the power cord into a grounded 120 volt outlet. (Please see image #1 below).
3. Connect the Quick Connect Valve Adaptor to tire air valve by pushing the valve lever down until it is
securely attached to the tire air valve. (Please see image #2 below).
4. Turn the inflator on by pushing the On/Off power switch to the "I" position. Monitor the PSI on the
pressure gauge to fill your tire to desired air pressure.
5. Once you have reached the desired air pressure, move the On/Off power switch to the "O" position.
6. Remove the air hose from the tire by lifting up on the valve lever. You will then easily lift the valve lever
upward and it will easily release from the valve you were inflating.
7. Unplug the power cord from 120 volt outlet.
To inflate sports ball, air mattress, rubber raft, etc.:
Place inflator evenly on flat surface.
1.
Plug the power cord into a grounded 120 volt outlet. (Please see image #1 below).
2.
Select the appropriate inflation accessory and insert into Quick Connect Valve Adaptor by pushing the
3.
valve lever down until it is securely attached.
Insert the inflation accessory into desired item you are inflating.
4.
Move the On/Off switch to "I" position and the inflator will begin to operate. Inflate your item to the
5.
desired pressure and move the On/Off switch to the "O" position.
Remove inflation accessory from Quick Connect Valve Adaptor.
6.
Unplug the power cord from 120 volt outlet.
7.
OPERATING INSTRUCTIONS
DO NOT OVER-INFLATE ITEM BEING INFLATED.
Image #1
Image #2
4
Publicidad
