Honeywell Home T6 Pro Z-Wave TH6320ZW2003 Guia De Instalacion página 20

Z-Wave configuration parameters
If your gateway/hub/controller supports configuration function, you may remotely
configure or change the default thermostat configuration parameters. For detailed
table with all available Z-Wave configuration parameters, search for T6 Pro Z-Wave
Thermostat in the Z-Wave certified products section on http://Z-Wavealliance.org
Performing a system test
You can test the system setup in ADVANCED
MENU under SYSTEM TEST option.
Press and hold Menu on the thermostat for
1
5 seconds to access ADVANCED MENU
options.
2 Touch or
3 Touch Select or touch text area.
4 Touch or
Touch Select or touch text area.
5 For the heat test and cool test, use
to activate each stage of the equipment.
For the fan test, use
on and off.
NOTE: The clock is used as a timer while the
stages are running. The Heat On and Cool On
indicators are displayed when the system test
is running.
Viewing equipment status
You can see the status of thermostat-
controlled equipment in the Menu under the
EQMT STATUS option.
1 Touch Menu on your thermostat.
2 Touch or
Touch Select or touch text area.
3 Touch or
equipment the thermostat is controlling.
Depending on what feature the thermostat
supports or how it was installed, the
Equipment Status screen reports data for
the following systems:
• Heating and cooling
• Fan
Identify thermostat: (TH6320ZW2007 only). If the thermostat is included in a Z-Wave
Network. You can choose to identify the thermostat via Z-Wave app. Backlight will flash.
Touching display while flashing will stop Identify mode. This is helpful when multiple
thermostats are on the same Z-Wave Network.
to go to SYSTEM TEST.
to select system test type.
or to turn the fan
to go to EQMT STATUS.
to view statuses of all the
or
Back
20
Back Select
Heat On
Heat
Done
Select
Back Select
Done