Publicidad
Idiomas disponibles
Idiomas disponibles
EN
•
lnstallation and electrical connections must be carried out by qualified
personnel only. Carefully follow all regulations regarding installation and sy-
stems that are applicable in the country where the product is to be installed.
IMPORTANT:
•
This article must be protected by a differential switch with IΔn ≤ 30 mA.
•
Before any operation (cleaning - installing the mirror)always disconnect the
power supply.
•
Before installing, check that the position chosen is compliant with require-
ments for safety distances under the standards of the country where the
product is to be installed.
•
The instruction sheet must be kept and made available to personnel entru-
sted with cleaning/maintenance operations.
•
The wall-fastening system provided is suitable only for solid walls or bricks.
•
The article is suitable for indoor use only.
•
The light source of this luminaire is not replaceable; when the light source
reaches its end of life whole luminaire shall be replaced.
•
lf the wire and/or some other components are damaged, they must be
immediately replaced with spare parts. This should be done only by specia-
lized people, to ensure product safety. INDA disclaims any liability for failure
to comply with this obligation.
•
Connect the appliance directly to the wall.
•
Classification under EN 62471:2008: 'Exempt Group' for photobiological
risks.
IMPORTANT:
•
Turn off the main power switch before installation.
•
Always turn off the main power switch to disconnect the article before ope-
ning it.
•
The cable for connection to the mains power supply must be of the type
H03VVH2-F 2x0.75 mm
INSTALLATION WITH WALL UNIT:
•
Decide at which height H above the floor you wish to place the mirror (fig.3).
•
Provide a shunt box with on outlet tube to connect the mirror at distance of
about 10 cm.
•
Unscrew the screws, then release the sliding panel C from the base E by
removing the wire from the terminal.
•
lnstall the wall flange C and mark off the fixture holes (fig.3).
•
Make the holes with a drill Ø6 (fig.3).
•
Pull out the cable of the mirror (fig.3).
•
Fix the wall plate C with the screws and dowels provided (fig.5).
(SCHUKO).
2
8
Publicidad
