Risco RWT6CO Instrucciones De Instalación página 6

• Placing at eye level allows for optimum monitoring of the red and green indicator
lights.
• Ensure that all vents of the unit are unobstructed.
• Do not install in dead air spaces such as peaks of vaulted ceilings, or gabled roofs.
• Do not install in turbulent air from ceiling fans.
• Do not place near fresh air vents or close to doors and windows that open to the
outside.
• Keep the CO detector away from excessively dusty, dirty, or greasy areas such as
kitchens, garages and furnace rooms. Dust, grease and household chemicals can affect
the sensor.
• Keep out of damp and humid areas such as the bathroom. Avoid spraying aerosols
near the CO detector.
Step 3: Mounting
TEST /
SILENCE
Button
1. Drill two ф5.0mm holes in the wall; the distance between two holes center should be
52mm (2 inches).
2. Insert the two supplied plastic stoppers into the holes until the screw heads are
approximately 5mm from the wall.
3. Test the unit by pressing the TEST/SILENCE button (see Figure 2). Ensure the unit
sound is of the alarm pattern.
4. Hook the unit over the screws and then onto the keyholes in the back of unit.
Figure 2 – Mounting
6