Using The Cooler - Dometic CFX Serie Instrucciones De Uso

CFX100W
7.5

Using the cooler

A
NOTICE! Danger of overheating!
Ensure at all times that there is sufficient ventilation so that the heat that
generated during operation can dissipate. Ensure that the ventilation
slots are not covered. Make sure that the device is sufficiently far away
from walls and other objects so that the air can circulate.
➤ Place the cooler on a firm foundation.
Make sure that the ventilation slots are not covered and that the heated air can
dissipate.
I
NOTE
Place the cooler as shown (fig. 1, page 3). If you operate the box in a
different orientation it can be damaged.
➤ Connect the cooler, see chapter "Connecting the cooler" on page 19.
A
NOTICE! Danger from excessively low temperature!
Ensure that the only those objects are placed in the cooler that are
intended to be cooled at the selected temperature.
➤ Press the "ON/OFF" button (fig. 3 1, page 4) for between one and two
seconds.
✓ The LED "P" lights up (fig. 3 2, page 4).
✓ The display (fig. 3 5, page 4) switches on and shows the current temperature.
✓ The cooler starts cooling the interior.
I
NOTE
When operating with the battery, the display switches off automatically
if the battery voltage is low. The LED "P" flashes orange.
Latching the cooler lid
➤ Close the lid.
➤ Press the latches (fig. 2 1, page 3) down, until they latch in place audibly.
I
NOTE – "Lid open" alarm
If the lid is left open for three minutes or more and the device is switched
on, the interior light will flash until the lid is closed.
EN
Operation
23