LGB Rhatia 26273 Manual De Instrucciones página 8

Safety Notes
• This model may only be used with the operating system designed for it.
• Use only switched mode power supply units and transformers that are designed
for your local power system.
• This locomotive must never be supplied with power from more than one power pack.
• Pay close attention to the safety notes in the instructions for your operating system.
• Not for children under the age of 15.
• WARNING! Sharp edges and points required for operation.
• WARNING! This product contains magnets. Swallowing more than one magnet may
cause death in certain circumstances. If necessary, see a doctor immediately.
Important Notes
• The operating instructions are a component part of the product and must therefore
be kept in a safe place as well as included with the product, if the latter is given to
someone else.
• The warranty card included with this product speci es the warranty conditions.
• Please see your authorized LGB dealer for repairs or spare parts.
• Disposing: www.maerklin.com/en/imprint.html
Functions
• This model is designed for operation on LGB two-rail DC systems with conventio-
nal LGB DC train controllers or power packs (DC, 0 – 24 volts).
• Factory-installed multiple protocol decoder (DC, DCC, mfx).
• The model is programmed with locomotive address 03 for use with the LGB Multi
Train System (DCC). The locomotive is automatically recognized in operation with mfx.
• Mfx technology for the Mobile Station/Central Station.
Name set at the factory: RhB 1 Rhaetia
• The functions can be activated only in parallel. Serial activation of the functions is
not possible (Please note here the instructions for your controller).
General Note to Avoid Electromagnetic Interference:
A permanent, awless wheel-rail contact is required in order to guarantee operation
for which a model is designed. Do not make any changes to current-conducting parts.
Mode of Operation Switch
The model has two mode switches in the water boxes (Fig. 1-3).
Left switch: Smoke on/off
Right switch: whole locomotive on/off
Smoke Generator
In analog operation, the smoke generator synchronized to the wheels is turned off
due to its power draw. This can be turned on by setting CV 13 from Value 32 to Value
96, but this may affect the running characteristics when running very slowly – depen-
ding on the current supply.
The smoke generator may be lled with a maximum of 5 – 6 milliliters / 0.2 uid
ounces of (Märklin) 2421 smoke uid.
Sound
The whistle can be activated with the LGB sound activation magnet (item no. 17050)
that is included with the locomotive. The activation magnet can be clipped into place
between the ties of most LGB track sections. Place the magnet on the right side in or-
der to activate the short whistle blast when the locomotive passes over this location.
The long whistle blast will sound when the magnet is placed on the left side.
"Coupling" function
This function is a programmed automatic sequence for uncoupling attached railroad
cars. The coupling is rst relieved of the load and then uncoupled.
This function is only possible when stationary. It only works if no hook coupling is
tted to the car.
This model is recreated as far as possible from the prototype and has been realized
without great compromises. Carefully laid trackwork is therefore a requirement for
trouble-free operation of the locomotive. Performance impairments may possibly
occur on the 12360 three-way turnout when the locomotive is on the branch of the
turnout – depending on the condition of the turnout. In these cases, the wheel steering
supplement included with the locomotive must be installed on the turnout (see page 32).
Additional wheel steering supplements can be ordered from Märklin Service.
8