Whirlpool OMR555RR0X Guía Rápida

Quick guide
THANK YOU FOR BUYING A WHIRLPOOL
PRODUCT
In order to receive a more complete
assistance, please register your product on
www . whirlpool . eu/register
CONTROL PANEL DESCRIPTION
1
1. SELECTION KNOB
For switching the oven on by selecting
a function. Turn to position to switch
the oven off.
2. LIGHT
With the oven switched on, press
to turn the oven compartment lamp on
or off.
SLIDING SHELVES AND SHELF GUIDES
Before using the oven remove the protective tape [a] and then
remove the protective foil [b] from the sliding runners.
REMOVING THE SLIDING RUNNERS [c]
Pull the lower part of the sliding runner to uncouple the lower
hooks (1) and pull the the sliding runners upwards, removing
them from the upper hooks (2).
REFITTING THE SLIDING RUNNERS [d]
Hook the upper hooks on the shelf guides (1) then press the
lower part of the sliding runners against the shelf guides, until
the lower hooks are clicking (2).
FIRST TIME USE
1. SETTING THE TIME
You will need to set the time when you switch on the
appliance for the first time: Press
two digits for the hour start flashing on the display.
Use or to set the hour and press
two digits for the minutes will start flashing. Use
set the minutes and press
2 3
3. SETTING THE TIME
For accessing the cooking time settings,
delayed start and timer.
For displaying the time when the oven
is off.
4. DISPLAY
5. ADJUSTMENT BUTTONS
For changing the cooking time settings.
until the icon and the
to confirm. The
or
to confirm.
Before using the appliance carefully read the Safety
Instruction.
4 5
2
1
REMOVING AND REFITTING THE SHELF GUIDES
1. To remove the shelf guides, firmly grip the external part of
the guide, and pull it towards you to extract the support and
the two internal pins from the lodging.
2. To reposition the shelf guides, position them near the cavity
and initially insert the two pins into their lodgings. Next,
position the external part near its lodging, insert the support,
and firmly press towards the wall of the cavity to make sure
the shelf guide is properly secured.
Please note: When the
lengthy power outages, you will need to reset the time.
2. SET THE POWER CONSUMPTION
By default the oven is programmed to work at a power
higher than 3 kW (Hi): To operate the oven at a power that is
compatible with a domestic power supply less than 2,9 kW
(Lo), you will need to change the settings.
To go to the change menu, turn the selection knob to
then turn it back to
to
6
6. THERMOSTAT KNOB
Turn to select the temperature you require
when activating manual functions.
Please note: Type of knobs may vary from
model type. If the knobs are push-activated,
push down on the center of the knob to
release it from seating.
[c]
icon is flashing, for example following
.
EN
1
2
[d]
,