Publicidad
Idiomas disponibles
Idiomas disponibles
the carrier within a maximum period of 24 hours after
the receipt of the goods.
Remove the equipment and accessories from the card-
board packaging, removing the corresponding protec-
tions.
ATTENTION: Dispose of properly and keep out of
reach of children the plastic bags, as they can be
a danger to them.
Inside you will find: Water treatment equipment, insta-
llation accessories and documentation.
The materials used in the packaging are recyclable and
must be disposed of in the appropriate separate co-
llection containers or in the specific local center for the
recovery of waste materials.
This product cannot be disposed of toge-
ther with the usual municipal waste. When
the useful life of the equipment has been
completed, it must be delivered to the
company or center where the device was
acquired, or to a Specific Clean Point or
local center for the recovery of materials,
indicating that it has electrical and elec-
tronic components. The correct collection and treat-
ment of unusable equipment contributes to preserving
natural resources and also to avoiding potential risks to
public health.
5. INSTALLATION
The installation of your osmosis equipment must be carried
out by sufficiently qualified personnel. Read this manual in
advance and consult with the dealer if in doubt.
ATTENTION: Since the apparatus to be installed
improves the quality of the water to be dischar-
ged, all tools to be used for assembly and installation
must be clean and in no case may be contaminated or
impregnated with fats, oils or oxides. Use tools for ex-
clusive use for tube cutting, membrane manipulation,
etc. Keep them clean and disinfect them periodically.
ATTENTION: The work must be carried out with an
attitude and adequate hygienic conditions, extre-
me the precautions in everything related to materials
and components that will find is in contact with the
water to be treated or consumed.
(For more information contact your distributor).
ATTENTION: Avoid the risks of external contami-
nation of the equipment by improper handling,
using gloves, hand sanitizing gel or washing hands as
many times as necessary.
The most common place for installation of the unit is
usually under the kitchen sink or in an adjoining cabinet.
Install the tap, hydraulically and electrically, to the
equipment drain collar and inlet adaptor and connect
them to the respective equipment connectors (5, 6, 6.1
and 7).
Technical Manual
5
� 16 mm
6
6 mm
6.1
7
See hydraulic diagram on page 21.
ATTENTION: Some of the accessories of the installa-
tion may vary depending on the model and the region
in which the equipment is distributed.
5.1. MIXING KIT
• In case you want to increase the pH, conductivity and chlo-
rine concentration at the outlet, you will need to carry out
the installation according to the following scheme and using
the component cores included in the mixing kit (check with
your distributor).
• After start-up, open the tap and with the corresponding
meter of the parameter of interest, measure in the water
dispensed by the tap and slowly and progressively open the
mixing valve until you get the desired result.
• The water dispensed must comply with the requirements
of potability established by the European Directive 98/83 or
corresponding national legislation that applies.
� The smart faucet su-
ministered with the team
has a cable connection.
The use of a 16 mm bit for
your installation.
� Clamp for the
40 mm drain.
� Adapter and key
input step for co-
3/8" annexations.
Publicidad
