Crosby IP IPBC Manual Del Usuario página 6

Idiomas disponibles

These areas of damage, precisely as wear, are not covered by the warranty.

In most cases however the areas of damage are much less extensive. In doubtful cases an author-

ised repairer should assess the clamp.

How to operate the clamp

IPBC lifting clamps are suitable for the horizontal lifting and transport of one or more steel plates,

beams and structures as well as tilting beams from position H to position I.

See illustrations 3 - 11 for part reference.

Lifting

1. Open the clamp by pulling up the grip on the camsegment (B) (3).

2. Place the clamp securely on the material to be lifted, so that the jaw of the clamp rests against

the plate or flange (E). Keep base against the load (4).

3. Close the clamp by letting go the grip. The clamp will remain on the material in pretensioned

position, allowing lifting to commence (5).

4. As soon as the load is at its destination let the crane hook descend until the clamp is fully free

of load, meaning that the lifting chain is no longer taut.

5. The clamp can now be removed from the load by pulling up the camsegment (B) again. The

clamp may now be used again immediately (6).

Tilting

1. Open the clamp by pulling up the grip on the camsegment (B) (7).

2. Place the clamp securely on the material to be lifted, so that the jaw of the clamp rests against

the plate or flange (E). Keep base against the load (8).

3. Close the clamp by letting go the grip. The clamp will remain on the material in pretensioned

position, allowing lifting to commence (9).

4. Pull gently the chain taut. By continuing the lifting, the clamp will tilt over to point R. At a certain

moment the beam will tip to the I-position (10).

5. As soon as the load is at its destination let the crane hook descend until the clamp is fully free

of load, meaning that the lifting chain is no longer taut.

6. The clamp can now be removed from the load by pulling up the camsegment (B) again. The

clamp may now be used again immediately (11).

A reliable clamp, a secure basis for lifting

10 Year warranty preventive maintenance procedure:

Parts should be replaced only when they no longer meet our standards.

10 Year warranty repair procedure:

During every repair service the most critical parts, being pivot(s), camsegment and spring will be

replaced and, when necessary, any rejected parts will be replaced.

Please consult www.thecrosbygroup.com/resources/crosbyip-10-year-guarantee for more infor-

mation on maintenance procedures.

Maintenance without 10 year warranty: Annually clamps are subjected to inspection* and parts will

be replaced only when they no longer meet our standards.

*CrosbyIP authorised repairer