Vito Agro VIBCRSBSFL40 Manual De Instrucciones página 32

ASSEMBLY INSTRUCTIONS
Batteries
1. Insert the batteries (8) on the groove and slip them
all the way until you hear a "click" noise from the
lock/unlock button. At this point, the battery is
locked in place;
2. To remove the battery, press the lock/unlock button
and pull out the battery.
Use VITO 20V lithium-ion batteries.
Charging the batteries
1. Place the batteries in the charger in the same way as
you would place it in the appliance;
2. Plug the charger into the socket and let it charge.
Sometimes at the end of charging, both the batteries
and the charger can be hot, which doesn't mean they
malfunction.
Let the battery cool down before putting it in the
cordless split brush cutter.
Handlebar
1. Loosen the handlebar tightening bolt (12);
2. While holding the bottom of the bracket, remove the
bolt and the top of the bracket;
3. Place the handlebar in the bracket;
4. Refit the upper part of the bracket and the bolt;
5. Tighten the bolt.
Adjust the handlebar before tightening the bolt
completely.
Front shaft
1. Unscrew the wing bolt;
2. Insert the front shaft (3) into the brush cutter main
body (9);
3. Retighten the wing bolt.
32
Guard
The guard avoids the projection of loose objects and
accidental contact of the blade or nylon line with the
user.
1. Attach (14) the guard to the shaft and tighten the 3
screws;
2. Secure the edge of the guard, using the 3 screws.
The guard does not protect the user against all
objects (stones, glass, wire, etc) that fly off from
the cutting attachment. These objects can bounce off
and hit the user.
Blade
Check the blade condition before installing it to the
appliance. If it is damaged (cracked, bent or broken)
replace it.
1. Place the locking washer on the shaft;
2. Place the thrust plate;
3. Insert the blade (1) and the support cup (15);
4. Turn the blade shaft until the hole of the lock washer
is aligned with the protective cover;
5. Insert the locking pin into the hole to lock the shaft;
6. Place the lock nut on. To tighten the nut, turn the
wrench in the opposite direction to the direction of
rotation;
7. Remove the locking pin after having finished the
installation.
Mowing head with nylon line
1. Place the locking washer on the shaft;
2. Place the thrust plate;
3. Turn the blade shaft until the hole of the lock washer
is aligned with the protective cover;
4. Insert the locking pin into the hole to lock the shaft;
5. Screw the mowing head in the opposite direction to
the direction of rotation;
6. Remove the locking pin after having finished the
installation.