Sauder Costa Serie Manual Del Usuario página 28

Step 22
å
Turn two BLACK 9/16" FLAT HEAD SCREWS (32S) into the END (E)
until the shoulders of the SCREWS rest on the surface of the END.
å
NOTE: Do not overtighten the SCREWS.
å
Slide the remaining END MOLDING (F) onto the END (E). Line up the
groove in the MOLDING over the heads of the SCREWS in the END.
å
NOTE: The MOLDING should be even on both edges of the END.
å
NOTE: If the MOLDING comes up off of the SCREWS, remove it and
slide it on again.
Page 28
BLACK 9/16" FLAT HEAD SCREW
E
430237
32S
(2 used in this step)
Shoulder
Apply pressure with your hands
as you guide the MOLDING over
the SCREWS and onto the END.
DRAWER ON LEFT
F
www.sauder.com/service