Sauder Costa Serie Manual Del Usuario página 58

Step 48
1
D583
U
Groove
å
Insert the DRAWER SIDES (D583 and D584) at an angle
into the slot at each end of the DRAWER FRONT (U).
3
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
D583
BACK groove.
å
Fasten the DRAWER BACK (D78) to the DRAWER SIDES (D583 and D584).
Use four BLACK 1-9/16" FLAT HEAD SCREWS (30S).
å
NOTE: Be sure the DRAWER BOTTOM (B61) inserts into the groove of the DRAWER BACK (D78).
Page 58
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D584
D78
B61
2
B61
U n fi
s u r
f a c
D583
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Slide the DRAWER BOTTOM (B61) into the grooves
in the DRAWER SIDES (D583 and D584) and
DRAWER FRONT (U).
D584
430237
With the palm of
your hand, tap
the DRAWER
BOTTOM down
into the groove.
n i s h
e d
e
D584
U
Start each screw a few turns before
completely tightening any of them.
30S
BLACK 1-9/16" FLAT HEAD SCREW
(4 used in this step)
www.sauder.com/service
9